Skipper Clamp Holder Receiver

The clamp holder/receiver is used to attach the Skipper XS Unit and/or tape end to angular surfaces such as door frames, work surfaces and racking. Simply position the clamp in place and turn the screw to tighten. The clamp holder/receiver can be positioned either horizontally or vertically depending on the desired application.

The clamp has a connector slot which allows it to receive tape end clips from both the standard Skipper Units and Skipper XS Units. It cannot be used to hold a standard Skipper Unit, but will hold the Skipper XS Unit.

The clamp holder/receiver will attach to a surface up to 97mm wide.

• Holds the Skipper XS Unit via its connector points or receives any Skipper tape end clip
• Perfect for door frames, worktops and racking Has an adjustable connector
• slot which allows it to connect both horizontally and vertically
• Simply adjust the lower clamp up and down the rail to fit the desired surface
• Soft pads to prevent scratching to surfaces